Filter
Top Products
30
Main Menu (continued)
31
SYSTEM CONFIG
Underlined values indicate factory defaults.
Submenu Setting Description
SUB WINDOW
FULL
PART
Selects sub-window type of the SUB WINDOW function.
[FULL] Reduces the entire input signal screen and turns it into two screens that are
displayed side by side.
[PART] Removes the center portion of the input signal screen and turns it into two
screens that are placed side by side. (The center portion is displayed at its
original size)
MENU POSITION
CENTER
LT
RT
RB
LB
Positions the on-screen menu.
[CENTER] Center of screen
[LT] Top left [RT] Top right
[RB] Bottom right [LB] Bottom left
STATUS DISPLAY
OFF
3SEC OFF
CONTINUE
Determines how operating status (→page 16) is displayed.
[OFF] Not displayed.
[3SEC OFF] Displayed for approx.3 seconds after a status change.
*
1
[CONTINUE] Displayed at all times.
INPUT NAME
SETUP
▼
Changes the names of displayed input terminals in status display screens.
*
2
SETUP LOAD FACTORY
USER1
*
3
USER2
*
3
USER3
*
3
USER4
*
3
USER5
*
3
Loads saved factory defaults ([FACTORY]) or user data ([USER1] to [USER5]).(→page 22)
After loading user data, the screen displays the signal selected before user data was
loaded.
SETUP SAVE
USER1
USER2
USER3
USER4
USER5
Up to 5 sets of user data can be saved.(→page 22)
Adjustment values made with the rotary knob <PICTURE> and menu settings, except
[SETUP SAVE]/[SETUP LOAD] can be saved.
POWER ON SETUP
LAST
FACTORY
USER1
USER2
USER3
USER4
USER5
Selects the settings used when the power is turned on.
[LAST] Starts in the mode used when the power was last turned off.
[FACTORY] Starts up using the factory defaults.
[USER1] to [USER5] Starts up using USER registered settings.
COLOR SPACE
SMPTE-C
*
4
EBU
*
5
ITU-709
*
6
Sets the studio standard color shade.
POWER DOWN
OFF
ON
Determines whether or not the power will be turned off (powered down) when there is no
signal input and the monitor has been idle for a certain period of time.
[OFF] The monitor is not powered down. [ON] The monitor is powered down.
POWER SAVE
MODE
OFF
ON
Sets the power save mode
[OFF] POWER SAVE MODE is not engaged.
[ON] The backlight dims when no signal ([NO SIGNAL]) is input for approx.60 seconds
or longer. Signal input or menu operation will return the backlight to its normal
brightness.
CALIBRATION ▼ Connect a CA-310 Display color analyzer and use this submenu to make a calibration. This
also restores the calibration data to factory defaults.(→pages 32 to 33)
*
1
In PIXEL TO PIXEL and 3D assist mode, the [3SEC OFF] setting has the same effect as [CONTINUE].
*
2
Up to 9 characters can be entered for this monitor. Only alphabetic characters (English), numeric characters and symbols can be
used.
*
3
[USER1] to [USER 5] and [FACTORY] have the same factory defaults.
*
4
Factory default setting for the BT-LH2170P.
*
5
Factory default setting for the BT-LH2170E.
*
6
ITU-709 is an ITU-R BT.709 standard.