Panasonic BT-LH2170P Car Video System User Manual


 
48
49
3D Assist Mode
The unit is equipped with a 3D assist mode to provide support for shooting with a rig-type 3D camera system.
The 3D assist mode has the following functions.
Image input method: SIMULTANEOUS (simultaneous method)
Two types of image, one for the left eye (L) and one for the right eye (R), are input to the two SDI1 and SDI2 terminals.
• In 3D assist mode, the input is fixed to SDI1/SDI2 and the input line cannot be changed.
• A phase difference of up to ±15 µs between the SDI2 input signal and the SDI1 input signal, the reference, is appropriate.
• When the input signal formats of SDI1 and SDI2 are not identical or only one of the signals is input, the screen display will black out.
Assist functions
Assist Function
Name
Screen Indication Description
MIRROR Side-by-side Inverts the left and right and top and bottom of SDI1 (L) and SDI2 (R) images to
enable you to make basic 3D camera adjustments. (Half-mirror type supported)
SHIFT Overlay Shifts SDI2 (R) image horizontally and vertically to enable the lens axis of the 3D
camera to be checked.
COMPARISON Side-by-side, top
and bottom
Displays a halftone marker on the inside. A subject captured with only the camera of the
L or R can be checked.
CONVERGENCE Normal screen
display
Switches the L/R images automatically or manually to enable the convergence point to
be checked.
COLOR Overlay Overlays the L/R images on a checkerboard pattern to enable the brightness or color
offset to be checked.
ZOOM FOCUS Side-by-side Enlarges part of an image to enable the focus offset or zoom offset to be checked.
VERTICAL Side-by-side Displays the horizontal line markers to enable the vertical offset to be checked.
OVERLAY Overlay Displays the vertical line markers to enable the width of parallax to be checked.
How to switch to 3D assist mode
Select [3D ASSIST] in [2D/3D ASSIST] in the [MAIN MENU]
(main menu). The assist functions starts, and a status screen
like the one shown in the figure on the rights appears.
1
Indicates the name of the assist function selected with
the rotary knob <PICTURE>.
2
Indicates the format of the signal input to SDI1.
3
Indicates the format of the signal input to SDI2.
4
Opens the [3D ASSIST MENU] when the rotary knob
<PICTURE> is pressed.
• Select [3D ASSIST] to open the 3D assist menu.
• Select [PICTURE] to open the [PICTURE] (picture adjust-
ing) menu. (→page 21)
VOLUMEPICTURE
MENU RETURN
3D ASSIST - MIRROR-
SDI1(L): 1080/60i(L) SDI2(R): 1080/60i(R)
MENUEXIT
[3D ASSIST MENU]
3D ASSIST
PICTURE
1
2 3
4
<Note>
• When a signal on which the L/R information is superimposed is input to SDI1 such as when there is an AG-3DA1 or AG-3DP1 con-
nection, the L/R information is displayed on the right side of the signal format. When L and R are incorrectly input, the LR information
is displayed in yellow. When the L/R information is input to SDI2 only, the L/R information is not displayed on the right side of the
signal format.
How to switch the assist function
Turn the rotary knob <PICTURE>. Each clockwise turn switches the assist function in the order as shown below.
[MIRROR]→[SHIFT]→[COMPARISON]→[CONVERGENCE]→[COLOR]→[ZOOM FOCUS]→[VERTICAL]→[OVERLAY]