Filter
Top Products
27
DSR Series
BIT-7 BIT-6 BIT-5 BIT-4 BIT-3 BIT-2 BIT-1 BIT-0
VIDEOINSERT ASSEMBLE TIME CODE A2 A1
BIT-7 BIT-6 BIT-5 BIT-4 BIT-3 BIT-2 BIT-1 BIT-0
DA3 DA2 DA1DA4
1 : EDIT PRESET ON
0 : EDIT PRESET OFF
DATA-1 DATA-2 DATA-3 DATA-4
0 0
0 5 0 0 0 0
40.2D : LOST LOCK RESET
This command is used to reset the “DATA No. 8 BIT-6 : LOST LOCK” of the “7X.20 : STA-
TUS DATA”.
The LOST LOCK status will be set when the capstan and drum servo is locked over 10 second,
and then servo is unlocked in the PLAY, REC or EDIT mode.
4X.30 : EDIT PRESET
This command is used to select the edit mode and the video/audio preset channels.
The DEVICE sets all channels to “1” when the ASSEMBLE mode is selected.
[DATA-1]
[DATA-2]
In the case of “41.30” command, the channel to be preset by BIT-1 and BIT-0 of DATA-1
depends on the setting A1 EDIT CH and A2 EDIT CH.
In the case of “42.30” command, the setting of A1 EDIT CH, A2 EDIT CH or the setup menu
becomes invalid, and the preset channel is selected according to the contents of DATA-1 and
DATA-2.
When receiving this command during editing or rehearsal, the DEVICE sets the preset channel
after passing edit delay time. Refer to “20.61 : FULL EE ON”.
For the timing, refer to APPENDIX-1.
The items of the setup menu are different from the model.
44.31 : PREROLL TIME PRESET
This command is used to preset the preroll time, which has given by the DATA-1 through
DATA-4, to the DEVICE.
For the data format, refer to “24.31 : CUE UP WITH DATA”.
Example) Preroll Time=5 sec.
Model Item of setup menu
DSR-80/80P, A1 EDIT CH
DSR-85/85P A2 EDIT CH
DSR-2000/2000P 311 : EDIT REPLACE 1
DSR-2000A/2000AP 312 : EDIT REPLACE 2
313 : EDIT REPLACE 3
314 : EDIT REPLACE 4