Filter
Top Products
32
DSR Series
BIT-7 BIT-6 BIT-5 BIT-4 BIT-3 BIT-2 BIT-1 BIT-0
CH-2CH-3CH-4 CH-1****
BIT-7 BIT-6 BIT-5 BIT-4 BIT-3 BIT-2 BIT-1 BIT-0
CH-2CH-3CH-4 CH-1****
DATA-1
DF/NDF
BIT6
0 NDF
1DF
41.9E : SUPERIMPOSE
This command is used to control the SUPERIMPOSE mode of the DEVICE according to the
value of DATA-1
[DATA-1]
00 : SUPERIMPOSE OFF
01 : SUPERIMPOSE ON
FF : Depends on the DEVICE.
4X.AE: AUDIO MONITOR CHANNEL SELECT
This command is used to select either the right and left of the audio channel to be monitored
every L/R.
DATA-3: Selects the left channel of the main channel to be monitored.
* : RESERVED
DATA-4: Selects the right channel of the main channel to be monitored.
* : RESERVED
Both the right and left channels can select multiple channels at the same time respectively.
40.C0 : TIMELINE STOP
This command is used to stop the TIMELINE (internal clock) of a DEVICE.
40.C1 : TIMELINE RUN
This command is used to start the TIMELINE (internal clock) of a DEVICE. For the timing,
refer to APPENDIX-3.
44.C3 : TIMELINE PRESET
This command is used to preset the time data on the TIMELINE (internal clock) of a device.
The preset can be executed only when the TIMELINE is stopped.
For the data format, refer to “24.31: CUE UP WITH DATA”.
Selection of either DF or NDF of the TIMELINE is performed in accordance with bit-6 of
DATA-1 as shown in the following table.
For the timing, refer to APPENDIX-3.