Filter
Top Products
75
DSR Series
7-4. Special Commands for HVR Series
In the HVR series, the extension commands are located in the DEVICE DEPENDENT area of the 9-pin
command table.
These commands interpret DATA-1 as CMD-3.
7-4-1. Command Table
COMMAND RETURN
HVR-1500 HVR-1500A
0X.FA.E5 : EXTEND VIDEO INPUT SELECT 10.01 : ACK XO
01.FB.E5 : EXTEND VIDEO INPUT SENSE 14.FB.E5 : EXTEND VIDEO INPUT STATUS XO
7-4-2. Detailed Description of Commands
0X.FA.E5 : EXTEND VIDEO INPUT SELECT
This command is used to select a video input source according to DATA-2 to DATA-4.
When DATA-4 is omitted and “0x00” is set, the default HD/SD setting of the model is selected.
[DATA-2]
[DATA-3]
[DATA-4]
This data can be omitted.
When this data is provided, specify the HD or SD mode according to DATA-4.
This data is invalid when specified input function is not provided due to no optional board, etc.
BIT-1 BIT-0 MODE
01 HD
10 SD
n
The DATA-4 setting is valid in the following cases.
. When DATA-2 BIT-1 “SDI” is set
. When DATA-2 BIT-0 “ANALOG” and DATA-3 BIT-1 “Y/Pb/Pr” are set
BIT-4
BIT-5
BIT-6
BIT-7
BIT-3 BIT-2 BIT-1 BIT-0
INTERNAL
SG
SDI ANALOG
BIT-4
BIT-5
BIT-6
BIT-7
BIT-3 BIT-2 BIT-1 BIT-0
S (Y/C) Y/Pb/Pr
COMPOSITE