Filter
Top Products
24
10.2. Broadcast Operation
Following 4 types of broadcasts are possible: All-Zone, Individual Zone, Group, and Message Broadcasts.
This section describes how to make each broadcast.
Step 1. Press the ALL-ZONE key.
The All-zone indicator and all zone indicators (1 – 5) will light. (Press
the ALL-ZONE key again to cancel.)
Go to Step 2 on the next page.
Step 1. Select the desired broadcast zone by pressing the ZONE key.
The corresponding zone indicator will light. It is also possible to
simultaneously select 2 or more zones. (To cancel the selection,
press the ZONE key again.)
Note: When the All-zone indicator remains lit, you can not cancel individual zones by pressing their Zone
keys. In this case, press the ALL-ZONE key to cancel all zones, then select individual Zones with their
keys.
Go to Step 2 on the next page.
Individual broadcast zones assigned to Groups 1 and 2 require to be programmed into the VM amplifier.
(See p. 51 "Zone-to-Group assignment.")
Example of Group 1 broadcast
Step 1. Select the desired zone group by pressing the GROUP key.
Both the selected group's indicator and the indicators of the zones
assigned to that group will light. It is also possible to simultaneously
select 2 groups.
Example of 2-group broadcast
(To cancel the selection, press the GROUP key again.)
Go to Step 2 on the next page.
(3) Group Broadcast Operation
(2) Individual Zone Broadcast Operation
(1) Simultaneous All-Zone Broadcast Operation
ALL-ZONE
ZONE 2
GROUP 1
Zone 1
Group 1
(Selected)
Zone 2
Zone 3
Zone 4
Broadcast
Zones
Zone 1
Group 1
(Selected)
Group 2
(Selected)
Zone 2
Zone 3
Zone 4
Zone 5
Broadcast
Zones