Filter
Top Products
60
26. NAME LABEL PREPARATION
26.1. Amplifier's Label Preparation
• Use the supplied labels to indicate the names of each input and output on the front panel. Write the name in
the label, and affix it under each input or output volume control. See p. 8 "NOMENCLATURE AND
FUNCTIONS" for the place the label is affixed to. When making the label with a word processor, etc., be
sure that its size is no larger than 24 mm x 6 mm.
• Use the supplied label to indicate the set position of each volume control.
26.2. Remote Microphone's Label Preparation
26.2.1. Name label type and usable paper
Label type
Name label A: For setting on the RM-200M's left side
Name label B: For setting on the RM-200M's right side, and RM-210
Paper: Under 0.2 mm thick
26.2.2. Preparing the name label
(1) Preparation by hand
Copy the "Pattern paper for hand writing" on the next page. After writing a name, cut out the pattern paper
aligning it with the cutting guidelines.
(2) Preparation by using a PC or word processor
Prepare and print according to the instructions given in the "Dimensional diagram for printing devices" on
p. 62. Then cut out to the instructed size.
26.2.3. Inserting the name label
• Fully insert the name label cut out to the instructed size into the label entry slit.
• To remove the label, pull it out of the slit using the tip of knife blade.
Remote
microphone
RM-200M
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Name label entry slit
Name label B
(already prepared and cut out)
Name label A