8 Printer Environment Settings
228
NetWare
This section explains how to install the machine onto a NetWare network. The following
information is provided:
Information Checklist – page 228
NetWare Environments – page 228
NetWare Installation – page 229
Installation Procedure – page 229
Network Communication Setup – page 230
NetWare Setup – page 231
Computer Setup – page 231
Test Print – page 231
Information Checklist
Before installing the machine onto a network, make sure that the following items are
available or have been performed.
If problems arise during the machine installation, refer to
Problem Solving on page 341
.
for assistance.
NetWare Environments
System configuration
The machine supports NetWare PServer mode in Bindery or NDS. NetWare 3.x/4.x/
5.x/6.x is required to support Bindery. NetWare 4.11 or later is required to support NDS.
In the PServer mode, the machine will function as a print server and print jobs from the
print queue. The machine uses one file server user license.
NOTE: The machine does not support RPrinter mode.
Item By
An existing operational NetWare network is required. These procedures
are not designed to install a NetWare network.
Customer
NetWare versions 3.x, 4.x, 5.x or 6.x Customer
Obtain and record the following information, if required:
• IPv4 address
• Gateway address
• Subnet mask
•Host name
NOTE: Only the IPv4 format is available for addresses.
Customer
Test the machine to make sure that it is fully installed and functioning
correctly.
Customer
Install the print driver. Customer
