EtherTalk
249
EtherTalk
This section explains how to set up the machine to operate on an EtherTalk network.
The following information is provided:
Information Checklist – page 249
EtherTalk Environments – page 249
EtherTalk Installation – page 250
Installation Procedure – page 250
Network Communication Setup – page 250
Computer Setup – page 250
Test Print – page 251
Information Checklist
Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
If problems are encountered during the machine installation, refer to
Problem Solving
on page 341
.
EtherTalk Environments
System configuration
As the machine supports EtherTalk protocol, you can print from a Macintosh.
NOTE: You will need the optional PostScript Kit to use EtherTalk for printing.
Target computers
The machine supports a Macintosh or Power Macintosh with the following OS:
• Mac OS 7.5 or later, 8.x, 9.x, or Mac OS X 10.x
Item By
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Customer
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.x Customer
Test the machine to make sure that it is fully installed and functioning
correctly.
Customer
Install the Adobe PS print driver, or PPD (optional). Customer
