A SERVICE OF

logo

15 Problem Solving
354
Stapler Faults
The following describes stapler troubles when the Finisher (optional) is installed.
Follow the procedures on the following pages when copies are not stapled or when
staples are bent. Contact your Xerox Welcome Center if the problem persists after you
have tried the following solutions.
If staples are stapled on the copies in the manner shown in the figures below, contact
your Xerox Welcome Center.
CAUTION
Be careful in removing jammed staples.
Unstapled
Bent staple
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with
center pressed in