63
6Setups
This chapter describes how to change the various defaults preset on the machine, how
to register the various items such as mailboxes and destinations, and how to configure
or change the System Administrator settings.
Setting Procedure
This section describes the basic setting procedure available in the System
Administration mode. Follow the steps below.
1. Enter the System Administration Mode – page 63
2. Configure a Feature – page 64
3. Exit the System Administration Mode – page 64
1. Enter the System Administration Mode
1.
Press the <Log In/Out> button
on the control panel.
2.
Enter the correct user ID using
the numeric keypad on the
control panel or the screen
keyboard. For information on
how to use the keyboard, refer
to New Recipients in the Fax
chapter of the User Guide.
NOTE: The default System Administrator ID is “11111”. If the Authentication feature is
enabled, you may also be required to enter a passcode. The default passcode is
“x-admin”. To change the user ID or passcode, refer to
System Administrator Settings
on page 138
.
<Log In/Out>
button
