Filter
Top Products
35
• Connect the ground lead to the GND terminal.
• Connect the memory lead to the BAT terminal.
• Connect the ignition lead to the IGN terminal.
• Plug an FM antenna cable from the FM Distribution System into the unit’s female antenna jack.
• Install the unit in your fixture.
B. Connect a processor’s audio inputs and outputs to a 958 in the Processor/EQ Group. Then connect the
processor/EQ unit’s DC power inputs to a 915X DC Expander Module.
• Connect a high quality RCA patch cable from the 958’s LEFT and RIGHT INPUT jacks to the EQ’s
input.
• Use additional RCA patch cables to connect a corresponding jack pair from the LEFT and RIGHT
FRONT OUTPUT to the unit’s Front output. Do the same for the unit’s Rear and Sub outputs.
• Connect the ground lead to the GND terminal.
• Connect the memory lead to the BAT terminal.
• Connect the ignition lead to the IGN terminal.
• Install the unit in your fixture.
C. Connect an amplifier’s audio signal inputs and outputs to a 942 module and DC power inputs to a 916X
DC Expander Module. Four DC harness assemblies were included with each 916X.
Connect the amp’s audio inputs and speaker outputs a the 942 Module.
• Connect a high quality RCA patch cable from the same numbered 942 LEFT and RIGHT AUDIO
jacks to the unit’s input.
• Use 14 - 16 gauge speaker wire to connect the unit’s Speaker outputs to a corresponding SPEAKER
OUTPUT terminal plug.
Now connect the amp’s DC power inputs to the 916X connected to its 942 module.
• Connect the amp’s ground lead to the BLACK wire in the harness.
• Connect the amp’s battery lead to the YELLOW wire in the harness.
• Connect the amp’s turn-on lead to the BLUE wire in the harness.
• Plug the connector on the other end of the harness onto a numbered amp position on the 916X
circuit board. No smoke and fire? Great!
Install the unit in your display fixture.
D. Install a pair of speakers in the Front Speaker Group.
Note: Factory-wired displays use two position terminal blocks marked (+) and (–) that are pre-wired
to 932 Speaker Modules. You may wish to extend the wiring location for speakers from the 932
module to a convenient spot in each speaker cavity in your display.