Filter
Top Products
Barco - RHDM-1701 - User manual 215
Addendum
NOTE
:
Power voltage specifications are available in the Technical specifications section.
To power-up the display unit:
• Place the display unit up-right (on a Barco stand) or mount the display unit safely into a rack.
• Connect the power cord of the appropriate power supply to the power connector at the back of
the display unit.
• Power up the display unit by switching the power switch on.
• The display unit will start-up (you should hear the ventilators spin) and perform some checks
before displaying an image on the screen. The status of the start-up checks can be followed by
the flashing of the indicator lights. The start-up can take up to 20 seconds. Please check the sec-
tion that deals with the indicator lights for more information.
7.9 Cleaning instructions
Before cleaning:
• Switch off the display unit.
• Remove the power cord from the mains.
Cleaning the LCD screen:
• Wipe the screen surface with a soft cleaning cloth.
• To remove stains, use a damp cloth with non-aggressive cleaning products:
Do NOT use abrasive cleaning agents, glass cleaner or tissue paper.
Do NOT use alcohol/solvents at higher concentration > 5%.
Use non-aggressive cleaning products (water or a solution of distilled water and IsoPropyl
Alcohol).
• Do not rub or push on the LCD screen. Rubbing with tissue can degrade the performance of the
LCD screen.
Cleaning the cover:
• Use a soft cloth to remove dust. If necessary, a vacuum cleaner can be used to clean the venti-
lation openings.
• Use a damp cloth (if necessary with some mild detergent) to remove stains.
• Do not use a scouring pad, or other tools that my scratch and damage the cover.
• Do not use strong detergents such as alcohol and thinner.