Filter
Top Products
40 Barco - RHDM-1701 - User manual
How to
3.3 How to view signals connected to the SDI input board
Figure 9: Input connectors SDI input board
The standard input board that is mounted in slot 1 is a SDI input board. The SDI input board has
two inputs that are separately connected with a loop-through output connector.
NOTE
:
The input signals are not available at the loop-through output connectors when the display unit is in hard standby
Up to 2 inputs can be applied to the SDI board simultaneously. In the table below the possible
combinations are shown:
To select a valid signal, open the input selection toolbox by pressing long (
) on the button of
the window in which the input signal has to be shown
or
.
The concept of selection and viewing of the valid signals is summarized in the figure below:
Input SDI board Input 1 Input 2
Possible inputs
SDI
HDSDI
3Gb/s (optional)
SDI
HDSDI
3Gb/s (optional)
Dual link (optional)
IN OUT
IN OUT
INPUT 1 INPUT 2
A1
B1
S
L
O
T
1