Filter
Top Products
NX-800/800H
12
6. GPS Receiver Connection
6-1. Installing the GPS receiver
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Remove the front panel from the transceiver.
3. Attach two cushions to the top of the GPS receiver.
4. Attach the GPS receiver to the shield case with two
cushions as shown in Figure 6-2.
5. Solder each lead of the GPS receiver to a necessary loca-
tion of each landing on the component side of the TX-RX
unit (A/2).
6. Place the GPS antenna cable in the hollow at the rear of
the chassis. (Fig. 6-2
q
)
Note: If the GPS receiver is installed, cut the base of the
convex tab of the top packing with a pair of nippers, or
similar tool. (Fig. 6-3
w
)
If the convex tab of the top packing is cut off, the water
proofi ng property is no longer guaranteed.
Note: You must setup using the KPG-111D.
TX-RX unit (A/2)
Solder land
OPT10
OPT11
AGND
26P_RD
26P_TD
TXD2
RXD2
OPT1
OPT3
OPT4
OPT5
5V_1
DTI
OPT8
TXO
OPT7
OPT2
OPT9
RXEO
TXI
RXEI
OPT6
POW
33V
5V_2
DGND
GPS receiver
Fig. 6-1
3M Double coated cushion
No. 4016 (or No. 4416)
30 x 25 mm
3M Double coated cushion
No. 4016 (or No. 4416)
30 x 25 mm
GPS receiver
:
Fig. 6-2
@
Fig. 6-3
INSTALLATION