Filter
Top Products
NX-800/800H
13
6-2.
Installing the GPS receiver together with the VGS-1
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Remove the front panel from the transceiver.
3. Attach a cushion to the bottom of the VGS-1 as shown in
Figure 6-5.
Note: Be sure not to cover the connector with the cush-
ion.
4. Insert the VGS-1 connector (CN1) into the TX-RX unit (A/2)
connector (CN595).
5. Perform step 3 to 6 of “6-1. Installing the GPS receiver”
described on page 13.
Note: You must setup using the KPG-111D.
TX-RX unit (A/2)
Solder land
OPT10
OPT11
AGND
26P_RD
26P_TD
TXD2
RXD2
OPT1
OPT3
OPT4
OPT5
5V_1
DTI
OPT8
TXO
OPT7
OPT2
OPT9
RXEO
TXI
RXEI
OPT6
POW
33V
5V_2
DGND
GPS receiver
Fig. 6-4
CN1
CN595
GPS receiver
VGS-1
Fig. 6-5
INSTALLATION