Filter
Top Products
NX-800/800H
7
3.
•
How to enter the password with the microphone key-
pad;
If you press a key while “CLONE LOCK” is displayed,
the number that was pressed is displayed on the trans-
ceiver. Each press of the key shifts the display in order
to the left. When you enter the password and press
the [
] key, “CLONE MODE” is displayed if the en-
tered password is correct. If the password is incorrect,
“CLONE LOCK” is redisplayed.
• How to enter the password with the [
] and [ ] keys;
If the [
] and [ ] keys is pressed while “CLONE LOCK”
is displayed, number (0 to 9) are displayd fl ashing. When
you press the [
] key, the currently selected number
is determined. If you press the [
] key after enterning
the password in this procedure, “CLONE MODE” is
displayed if the entered password is correct. If the pass-
word is incorrect, “CLONE LOCK” is redisplayed.
4. Power on the slave transceiver.
5. Connect the cloning cable (Part No. E30-3382-05) to the
modular microphone jacks on the master and slave.
6. Press the [
] key on the master while the master dis-
plays “CLONE MODE” The data of the master is sent to
the slave. While the slave is receiving the data, “PRO-
GRAM” is displayed. When cloning of data is completed,
the master displays “END”, and the slave automatically
operates in the User mode. The slave can then be oper-
ated by the same program as the master.
7. The other slave can be continuously cloned. When the
[
] key on the master is pressed while the master dis-
plays “END”, the master displays “CLONE MODE”.
Carry out the operation in step 4 to 6. Can not be cloned
if the overwrite password is programmed to the slave.
Note:
Only the same models can be cloned together.
Cloning cable
(E30-3382-05)
Fig. 2
8. Firmware Version Information
Turn the transceiver ON with the [ ] key held down.
Then, the version is displayed during holding the [
] key.
INSTALLATION
REALIGNMENT
1. Ignition Sense Cable (KCT-46: Option)
The KCT-46 is an optional cable for enabling the ignition
function. The ignition function lets you turn the power to
the transceiver on and off with the car ignition key.
1-1.
Connecting the KCT-46 cable to the transceiver
1. Open the KCT-46 fuse holder and insert a mini blade fuse
(3A). (
q
)
2. While holding a clear protective cover, remove the black
cap at the end of the yellow cable (ignition sense cable)
of the transceiver. (
w
)
3. Connect the plug of the KCT-46 to the yellow cable ter-
minal of the transceiver. (
e
)
4. Connect the other end of the KCT-46 to the ignition line
of the car. (
r
)
Note: You must setup using the KPG-111D.
:
@
.
;
Ignition line
of the car
F52-0019-05
Fig. 1