Filter
Top Products
95741 Sixth Edition 3-51
Rack-mountable Tray
6. Connect the 457 mm (18 in.) daisy-chain cable (PN 310292001) from the second 68-pin
connector to the next drive, if applicable (see the CSL drive tray in the figure).
Note: Use a 343 mm (13.5 in.) daisy-chain cable (PN 10083616) for the manual-mount
drive tray.
7. Install a terminator (PN 10148003) on the device at the end of the SCSI bus.
8. Repeat Step 2 through Step 7 for all other CSL or drive trays.
1. Drive tray (two drive installed)
2. CSL tray
3. SCSI daisy chain cable
4. SCSI terminator
5. SCSI cable to host
9. Go to “Power-On Rack” on page 3-52 if you are only installing SCSI drive/CSL trays.
4
5
1
3
C5326
5
5
4
3
2