Filter
Top Products
95741 Sixth Edition 3-35
Rack
Additional Tray Rack-hardware Installation
The instructions in this section are used when installing drive or CSL trays in
positions two through six on the RACK001. The drive tray instructions follow
below while the CSL instructions begin on page 3-37.
Drive Tray Additional Hardware
You will be removing a rack filler plate to enable installation of a drive tray.
1. Remove the decorative cover from the filler plate.
2. Remove the screws from the filler plate and remove the plate.
Note: The filler plate uses holes 3 and 10.
3. Reposition the captive nut from hole 10 to hole 8.
Note: Make sure to identify the starting point for numbering holes. You need to start
below the lowest point in the tray mounting plate. If you start immediately below
the slide-rail of the drive tray, the nut plate will be mounted too high.
1. Captive nut
E53256
1