Filter
Top Products
Dislodge a Stuck Tape
7-8 Sixth Edition 95741
SavingDump This is displayed while saving
the dump to EEPROM.
This is the normal display.
Wait for the dump to complete.
Start Init Initialization started. No action necessary.
Trapped The boot is trapped in a
closed loop.
If the IPL does not clear the condition,
replace the drive or CSL.
Unloading The tape cartridge is being
unloaded.
No action necessary.
UnWr(xxxx) The
Unload switch was
pressed while a write was
taking place.
Go to “UnWr xxxx Indication” on
page 7-12.
Write Prot The drive or CSL attempted to
write to a write-protected
tape.
A VolSafe tape is loaded and
the operator is trying to make
a dump, code, or data tape,
or build an MIR.
Change the switch on tape cartridge to
write-enable.
Remove VolSafe tape and insert a standard
cartridge.
Writing The drive or CSL is in write
mode.
No action necessary.
Table 7-2. Error Displays and Instructions (Continued)