Filter
Top Products
9738 Library Attachment
3-12 Sixth Edition 95741
Connect Drive and Library Cables
Follow these instructions to connect the drive to the power supply and library:
1. Locate the plastic bag containing the power cord.
2. Make sure the power switch on the power supply is in the OFF position.
3. Connect P2 of the drive power cable to the top jack (J2) on the power supply (see
figure), and the P53 connector to the top jack on the drive.
4. Connect the female end of the power cord to the power supply receptacle (J1), and the
male end of the cord to a power outlet in the library (see figure).
1. Power cord
2. Power supply cable
3. Power switch
5. Repeat Steps 1 through 4 for remaining drive positions.
Note: Use the figure below as a guide for routing the drive power cable from a power
supply to the proper drive.
• The lower-left power supply connects to Drive 0.
• The lower-right power supply connects to Drive 1.
• The upper-left power supply connects to Drive 2.
1. Drive 0
2. Drive 1
3. Drive 2
E53250
1
2
3
C5324
8
3
1
2