Filter
Top Products
Rack
3-34 Sixth Edition 95741
2. At the front of the cabinet, insert the slide-rail assembly between the vertical frame
member and the nut plate.
3. Adjust the mounting bracket at the rear of the slide-rail assembly until it seats between
the nut plate and the vertical frame member.
4. Use a T-25 driver to tighten the 10-32 screws only enough to prevent the slide-rail
assembly from falling.
1. Slide-rail mounting screws (4)
2. Slide-rail assembly
5. Extend the slide rail out the front of the cabinet.
6. Position the slide rail so the center section clears the vertical frame member.
7. Tighten the nut plate screws.
8. Tighten the slide bracket screws at the rear of the slide assembly.
9. Repeat Steps 1 through Step 8 for the other slide assembly.
1. Slide rail
2. Nut plate
3. Screw
4. Slide clearance
10. Proceed to “Rack-mountable Tray” on page 3-38 if this is the only tray being installed.
C5325
8
2
1
C5350
7
1
1
2
3
4