Classe Audio SSP-800/CT-SSP Car Speaker User Manual


  Open as PDF
of 70
 
15
• LEDashes(atpower-up)–theSSPisintheprocessofpower-
up initialization.
•
LED O – the SSP is powered on, fully operational, and the display
active.
• LEDashesrapidly(afterpower-up)–theACmainsvoltageis
out of range.
2 Menu On/Off Button
Press once to call up the main page of the menu system, which replaces the
normalfrontpageorHomepageoftheTouchscreenandOSD(On-Screen
Display). Press the Menu button again to revert to the Home page.
e menu system gives you control over operational details including:
system setup options, various display options (including the language used
by the menu system), and custom installation capabilities so that the SSP
integrates smoothly into the most complex systems. For more information,
see the Menu System later in this manual.
3 Touchscreen
e front panel touchscreen has two main functions:
• NavigationoftheSSPmenusandcontrolsbysimplytouching
the screen to make your selections.
• Viewingincomingvideofromtheselectedsource.
4 Audio Mute Control
e Mute button reduces the SSP volume by a pre-determined amount.
Pressing it a second time restores the volume to its previous level. is
behavior can be easily customized for very specic user requirements. (See
the section on Volume Setup for more information.)
NOTE: If you increase the volume using either the front panel
volume knob or the remote control while Mute is engaged, the
mute control disengages, and audio adjustments are executed
starting from the muted level. is is a safety measure to prevent
accidentally restoring the volume at unexpectedly high levels.
5 IR window
e location of the IR (infrared) sensor for the remote control is behind
this window. In most cases, there must be a clear path between the IR
window and the remote control in order for the SSP to acknowledge the
remote control commands.
IftheIRwindowisnotinview,forexampleifit’splacedinacabinetor
closet, then the rear panel IR input can be utilized for remote control use.
For more details about this option, see the IR input description in the Rear
Panel section found later in this manual.
In addition to receiving IR commands, the SSP can also transmit IR
commands to third-party learning remote controls. For more details about
this option, refer to the Teach IR description in the Menu Tree section
found later in this manual.
 previous next