Classe Audio SSP-800/CT-SSP Car Speaker User Manual


  Open as PDF
of 70
 
22
18 CAN-Bus Input and Output
CAN-Bus(ControllerAreaNetwork)allowsseveralClassécomponentsto
be connected together for simultaneous operation, such as switching from
On to Standby.UsingtheCAN-BusInputandOutputconnectors,the
Classé components can be daisy chained together and controlled via the
CAN-Businterface.
NOTE: e nal component in the daisy chain MUST have a
termination plug inserted into the CAN-Bus output.
Formoreinformation,refertotheCAN-Bussectionfoundlaterinthis
manual.
19 10-Channel Analog Outputs
e SSP supports ten analog audio outputs, with both balanced (XLR)
and single-ended (RCA) connections. Connect the appropriate Front
L/R, Sub, Surr L/R, and Rear L/R connectors to the appropriate power
ampliers.
NOTE: e Rear L/R connectors are only active when the
SSP output is setup for a 7.1-channel surround system and the
audio stream or the selected surround processing mode are providing
rear channel signals.
e Aux 1 and 2 outputs are programmable and can be used for the
following purposes:
• Assignedasa2-channeldown-mixoftheselectedmulti-channel
signal for either an analog recorder or a separate listening area.
• AssignedtofollowthemainFrontL/Rspeakersforuseina
biamplication arrangement.
• Oneorbothmaybeassignedasadditionalsubwooferswiththe
ability to select between mono, and stereo modes.
Refer to the Menu System section for more details regarding optional uses
for the auxiliary analog output channels.
NOTE: e Balanced (XLR) Output pin assignments adhere to
the AES (Audio Engineering Society) “Pin 2 = hot” standard. e
XLR male outputs carry the following pin assignments:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to the operating manuals of your balanced-input power
ampliers to verify that the pin assignments of their input
connectors adhere to this standard (Classé power ampliers are
compliant). If your ampliers are not compliant, ask your Classé
dealer for assistance.
 previous next