Classe Audio SSP-800/CT-SSP Car Speaker User Manual


  Open as PDF
of 70
 
29
Step 6 Power up the system!
NowyouarereadytopowerupyourSSPandyoursurroundsystem.
• TurntherearpanelpowerswitchoftheSSPtoON.
•
e initial power-up cycle of the SSP takes approximately 90 seconds.
During this time, the blue LED on the standby button ashes. (For the
CT-SSP,thestandbybuttonitselfwillashblue.)
• Whenthepower-upcycleiscomplete,theSSPentersStandbymode.
e LED (or standby button) stops ashing but remains illuminated,
indicating that the SSP is in Standby mode. Refer to the Front Panel
section, for more details about Standby mode.
• PresstheStandby button or the front panel touchscreen to bring the
SSP to its fully ON mode. e front panel touch screen displays a
blue screen with an “initializing” message and then switches to the
home page of the menu system. Refer to the Menu System section
found later in the manual for more information.
e physical setup of the SSP and system components is complete.
 previous next