Classe Audio SSP-800/CT-SSP Car Speaker User Manual


  Open as PDF
of 70
 
43
audio e Audio Input menu allows you to select the oset, delay, and favorite
processing settings, aecting how the audio from this input source is handled.
• oset is used to ensure that all analog source playback is at comparable
levels. ere can be signicant dierences in output levels among analog
sources (this is not a problem with digital sources), which can lead to
unexpected changes in volume when switching among multiple sources.
e SSP provides an oset adjustment range from -5 to +10 dB.
• delay
introduces an audio delay to compensate for a delayed video signal.
e delay is added to all channels and addresses the “lip sync” problems often
found with modern digital televisions using sophisticated video processing.
NOTE: If you see a consistent “lip sync” problem with all materials played by
this input source, then adjust the delay parameter to compensate for the issue.
However, if you only notice problems with a few specic materials, then leave
the input delay at its default value and make temporary adjustments to the
System Trims menu, available from the Home page, while playing the problem
source materials.
• favorite processing determines whether Dolby Volume is automatically
engaged when this source is selected. It also determines the default
surround mode that the SSP initially uses when it receives either a two
channel (“stereo”) or a multi-channel signal from the selected input source.
For example, you may want to use Dolby Pro Logic II Music as the default
mode for stereo signals from your CD player, while preferring plain two-
channelreproductionforthesignalfromyourFMtuner.Touchingeither
the 2-channel or the multi-channel buttons displays a list of the available
surround processing modes for the chosen signal type, from which you
may select your preferred default setting for this source.
• connector identies which rear panel connection the input should use.
Any of the rear panel audio inputs are assignable to any of the input setups.
• HDMI audio can only be assigned once an HDMI video connector has
been assigned to the input.
• bypass select determines if the incoming analog signal is converted to
digitalformatorleftinananalogformat.IftheBypassSelectisNOT
highlighted then the SSP converts all of the incoming analog signals to
digital for further processing. If you prefer to pass your signals through the
SSP unaltered, except for volume control, then touch the Bypass Select
button to make it active. NOTE: is option is automatically selected when
the Connector parameter is set to 7.1-bypass.
configuration e Conguration button allows you to assign one of the six conguration
optionsasthedefaultfortheinputbeingsetup.Ifyoudon’twantaspecic
conguration assigned to this input, select the No Default option. In this
case, the last used conguration is maintained when the input is selected.
Congurations are speaker setups, and are discussed in more detail later in this
section.
NOTE: e default Conguration assignment can be temporarily
overridden from the controls button on the Home page. See the section,
Using the SSP-800/CT-SSP, for more details.
 previous next