Classe Audio SSP-800/CT-SSP Car Speaker User Manual


  Open as PDF
of 70
 
36
controls TouchingtheControls option opens a new page, as shown below. e Controls
page allows you to adjust a variety of processor functions, such as audio levels
and delays, as well as selecting listening/speaker congurations.
eseadjustmentsaretemporary;whenanewinputisselected,theadjustments
are deleted and replaced with the saved values. If you want to recalibrate the
audio levels because of an equipment change, use the Speaker Setup menu, not
the Controls menu. Similarly, use the Input Setup menu to save a permanent
change to an audio delay or conguration preference.
system trims e System Trims pagecontrolsseveralparametersoftheSSP’soperationthat
mayoccasionallyneedadjustmenttosuitaparticularrecording.Touchingthe
SystemTrimsoptionopenstheSystemTrimsmenupage,asshownbelow.
e available adjustments are:
• level trims - provides Left/Right Balance, Center, Surround, Rear,
Subwoofer, and Aux1/2 level adjustments. As an example, you might want
to raise the level of the Center channel speaker by 2 or 3 dB if the dialog
in a particular movie is dicult to understand. In addition to the normal
subwoofer trims, two additional buttons (LFE 0dB, and LFE -10dB) oer
anextra-10dBoftrim.YoumayndcertainolderDTSMusicdiscswith
the LFE channel recorded 10dB higher than normal. e LFE -10dB
button allows you to quickly adjust for this scenario.
• audio delay - provides an overall delay, called Lipsync, to adjust for cases
where the timing of the video signal seems to trail the audio. You may run
into this problem with the occasional DVD, due to inattentive mastering
of the disc itself. If you nd this problem most of the time, then adjust
the delay setting for the input in the Setup menu. Remember that these
are only temporary trims, so use this system trim only for the occasional
adjustment needed for a specic disc or program.
 previous next