Filter
Top Products
13
9
REAR TALLYS (red)
Can be lit by a control signal from a GPI/
camera.
10
SDI1 (HD/SD) input terminal (BNC)
This is the SDI1 input terminal. (Compatible
with HD/SD automatic switching, Compatible
with 3G-SDI)
When you use 3D assist mode (page 51), input
images for the left eye (L).
11
SDI1 active through output terminal
This terminal outputs SDI1 input as is.
12
SDI2 (HD/SD) input terminal (BNC)
This is the SDI2 input terminal. (Compatible
with HD/SD automatic switching)
When you use 3D assist mode (page 51), input
images for the right eye (R).
13
SDI2 active through output terminal
This terminal outputs SDI2 input as is.
14
VIDEO/Y input terminal (BNC)
This is the VIDEO signal (component signal)
input terminal/Y signal (analog component
signal) input terminal.
15
P
B
/P
R
input terminal (BNC)
This is the P
B
/P
R
signal (analog component
signal) input terminal.
16
VF terminal (D-SUB, 15 pins)
This terminal connects to the VF (viewfinder)
terminal of broadcasting and business cameras
made by Panasonic.
The unit can be used as the viewfinder for such
a camera.
17
GPI input terminal (D-SUB, 9 pins)
External control is possible by using a GPI
signal.
18
SERIAL terminal (D-SUB, 9 pins)
External control is possible by using an RS-
232C interface.
19
HDMI input terminal
This is the HDMI input terminal.
20
DC IN terminal (XLR, 4 pins)
This is the external DC power supply input
terminal.
When a DC power supply is connected
concurrently with the battery, the external
power input takes precedence.
21
Battery holder
This holder is used with a battery made by
Anton/Bauer. (page 14)
22
Screw holes for fixing tripod
There are two screw holes on both the top and
bottom for fixing the unit to a tripod (compatible
with 3/8-16UNC). A removable adapter is
installed in one of the screw holes on the top
of the unit, and enables a 1/4-20UNC screw
to fit in the screw hole. Decide whether to
use the adapter depending on the diameter
of the tripod’s fixing screw. Use a flat-blade
screwdriver to remove or install the adapter.
23
Screw holes for multi-purpose fixing
There are four screw holes (M3) for multi-
purpose fixing on the rear of the unit, and two
on each the left and right.
Controls and Their Functions
(continued)
Rear panel
1112 10
9
22
1921 2023 23
13
14
15
16
17
18
22
9
SERIAL