Filter
Top Products
69
Error and Warning Displays
If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1 second
intervals to inform of the error/warning.
Error and Warning displays Symptom Remedy
Warning of improper
operation status for the
camera settings
!
is displayed.
Check the setting values of the
camera.*
2
Near end warning *
1
The voltage display flashes. Replace with a fully charged battery.
Battery level error *
1
“END BATTERY” is displayed for
approximately 3 seconds before
the power supply switches OFF.
Replace with a fully charged battery.
Set the BATTERY REMAIN menu item of the SYSTEM CONFIG menu to ON.
*
1
The condition to display differs depending on the type and settings of the camera used in combination
*
2
with the unit. For details, see the instruction manual of the camera.
Maintenance
To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.•
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out
to clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor
can cause a malfunction.
Never use alcohol, thinner or benzene to clean this unit.•
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
Do not spray cleansers directly onto the monitor.•
Water or similar substances getting inside the monitor can cause a malfunction.