Filter
Top Products
57
3D Assist Mode
(continued)
VERTICAL (Vertical Offset Check)
This function enables you to operate two horizontal line markers to check the number of lines between
markers in the displayed image and check vertical offset, which tends to cause eye fatigue.
FUNC.
EXPAND
MARKER1 MARKER2
13 Lines
DISP 384 384 VTCL
The number of lines of the displayed image is •
measured and then the number of lines between
the two horizontal line markers is displayed at the
bottom left of the screen.
Screen:
The L/R 2 screens are shown side-by-side, and two
markers are shown.
<Assist Points>
Displaying horizontal line markers makes it easy •
to check the left/right vertical offset.
If the vertical offset becomes large, discomfort will •
be felt and stereoscopic vision will become difficult
when the mode is set to 3D so make adjustments
trying your hardest to eliminate camera vertical
offset.
The underlined values are factory preset setting values.
Sub menu Operation Settings Description
EXPAND Knob1 (press)
DISP
×1
×2
Selects the display screen.
<DISP> Displays the full screen.
<×1>(x1) Displaysthescreenwiththeactualnumber
of pixels (PIXEL TO PIXEL)
<×2>(x2) Expandstheactualnumberofpixelsto
x2 in the vertical direction only and then
displays the screen.
Knob1 (turn)
T
C
B
Selects the display position for when the EXPAND
setting is x1 or x2.
*
1
<T> Displays the top of the input image.
<C> Displays the center of the input image.
<B> Displays the bottom of the input image.
MARKER1 Knob2 (turn)
0 - 384 - 767 Shifts the upper horizontal line marker up or down.
*
2
MARKER2 Knob3 (turn)
0 - 384 - 767 Shifts the lower horizontal line marker up or down.
*
2
When the signal format is 720P, the display position of the image is not shifted when x1 display.
*
1
The two horizontal line markers are each indicated by two lines, and the position of the upper line is
*
2
indicated.