Panasonic BT-LH910G Car Video System User Manual


  Open as PDF
of 76
 
43
Main Menu
(continued)
“WFM/VECTOR”
■
The “WFM/VECTOR” function enables display of the waveform and vector display. Use “DISPLAY
SETUP” in the main menu to select “WFM” and “VECTOR” display. (page 50)
Press the button ([FUNCTION1] to [FUNCTION3] (page 39)) to which the “WFM/VECTOR” function has
been assigned to switch the display in the following order.
WFM/VECTOROFF→WFMYON→WFMRON→WFMGON→WFMBON→VECTOR(x1tox8)
This assumes that the “WFM/VECTOR” function has been assigned to any of the [FUNCTION1] to •
[FUNCTION3] buttons.
WFM is displayed in the order of the Y signal, R signal, G signal, and B signal.
Normal screen
WFM display
(Y→R→G→B)
VECTOR display
*
1
Press the
button again
Press the
button again
WFM
(waveform display)
VECTOR
(vector display)
These examples show 16:9 aspect ratio images.
Displayed only for SDI signal input.
*
1
The scale display is as shown below.•
100 %
This dotted line is 109%.
A dotted line indicates for
each 10% increase.
This dotted line is -4%.
I axis
Q axis
The frame is ±2.5°, ±2.5 %
50 %
0 %
Press the FUNCTION button to which the WFM/VECTOR function has been assigned.
 previous next