Filter
Top Products
44
“PIXEL TO PIXEL” and “PIXEL POSITION”
■
The “PIXEL TO PIXEL” function allows you to check images at their actual pixel resolution (1080i/p
signals only).
Press the button ([FUNCTION1] to [FUNCTION3] (page 38)) to which the “PIXEL TO PIXEL” function has
been assigned to turn the function on. Then press the button ([FUNCTION1] to [FUNCTION3] (page 38))
to which the “PIXEL POSITION” function has been assigned to position the display of signals.
This assumes that the “PIXEL TO PIXEL” and “PIXEL POSITION” functions have been assigned to any •
of the [FUNCTION1] to [FUNCTION3] buttons.
The underlined values are factory preset setting values.
Item Settings Description
PIXEL TO PIXEL
*
1
*
2
OFF
ON
Sets whether to display the screen display size at the
input signal size.
<OFF> Not displayed. <ON> Displayed.
Compatible formats
1080/60i/59i/50i/60p/59p/50p/30p/29p/
25p/24p/23p/25PsF/24PsF/23PsF
PIXEL POSITION
CENTER
LT
RT
RB
LB
Positions the display of signals in PIXEL TO PIXEL mode.
<CENTER> Center of the screen
<LT> Left Top
<RT> Right Top
<RB> Right Bottom
<LB> Left Bottom
The following settings are disabled in PIXEL TO PIXEL mode.
*
1
Setting “ANAMO” to “ON”, and setting “SCAN” to “UNDER” in “VIDEO CONFIG”•
Any “HV DELAY” setting in “FUNCTION”•
“MARKER” display•
Enabled during “SDI1”, “SDI2”, “HDMI”, “YP
*
2
B
P
R
” and “VF (VF-YP
B
P
R
)” input.
“PIXEL POSITION” display position sequence
■
PIXEL POSITION:
→
→
→
→
→
.....
CENTER
LT (LEFT TOP)
RT (RIGHT TOP)
RB (RIGHT BOTTOM)
LB (LEFT BOTTOM)
Main Menu
(continued)