Filter
Top Products
2 – Front and rear panels–Rear Panel connectors
18 TASCAM DA-98HR
The pinout for this connector is given below .
s REMOTE IN/SYNC IN
This connector is used to connect another “master”
DTRS unit (e.g. DA-98HR, DA-78HR, DA-98, DA-
88 or DA-38). See 8, “DTRS synchronization” for
further details.
An RC-898, RC-848 or RC-828 remote control unit
may also be connected here, but unless an “HR
updated” RC-898 unit is used, not all functions of the
DA-98HR will be available from the remote control
unit.
t SYNC OUT
This is used to connect another DTRS unit in the
“daisy-chain” or, if this DA-98HR is the last unit in
the chain, to attach a termination plug.
u TDIF-1 (DIGITAL I/O)
This connector carries eight channels of digital audio
to and from the DA-98HR in TEAC Digital Interface
Format (TDIF-1).
v METER UNIT
This connector carries power and signals to drive 8
channels of the optional MU-8824 24-channel Meter
Unit.
Make the connection using a TASCAM PW-88M
cable.
w ~ IN
Use the provided AC power cord to connect the DA-
98HR to the AC power supply through this connec-
tor. Ensure that the power supplied is suitable for the
unit (as marked ). If you are in any doubt at all
regarding your power supply, consult a qualified
electrician.
Pin No. Signal Pin No. Signal
1PLAY 20SUB GND
2 F FWD 21 SERIAL OUT
3REW 22–
4 AUX 1 23 SERIAL IN
5STOP 24–
6REC 25–
7AUX 2 26–
8CHASE 27–
9 – 28 –
10 SUB GND 29 –
11 PLAY TALLLY 30 –
12 F FWD TALLY 31 –
13 REW TALLY 32 SRCK
14 STOP TALLY 33 –
15 REC TALLY 34 LOAD
16 LOCK TALLY 35 –
17 AUX 1 TALLY 36 SUB GND
18 AUX 2 TALLY 37 SUB 5 V (max
50mA)
19 ACTIVE SENSE