Tascam DA-98HR Car Stereo System User Manual


 
12 Maintenance and settingsUser setups in RAM
TASCAM DA-98HR 85
12.4 User setups in RAM
Commonly-used setups are saved in one of three user
setup memory banks: 1, 2 or 3. This enables pre-con-
figuration of the DA-98HR for different jobs (video
or film post-production, or different recording setups,
for example). There is also a preset memory bank
which contains the factory settings (see below).
When the DA-98HR is shipped, the contents of all
setup memories are the same; they contain the fac-
tory settings.
12.4.1 Saving user setups
1 Go to menu group 9, move the cursor to
Setup and press ENTER:
2 To save the current setup, press the § key
while the word
Load is flashing so that the
bottom line now reads
Save:
3 Move the cursor (Ó and Á keys) to
1, 2 or
3, and press the § key:
4 To save the current setup to the selected setup
memory, press the
ENTER key.
The word
Complete appears on the
screen for about 2 seconds and the user settings
are saved to the selected setup memory bank.
12.4.2 Loading user setups
1 Go to menu group 9, move the cursor to
Setup and press ENTER:
2 To load the setup memory into the current
memory, make sure the bottom line shows
Load:
3 Move the cursor to
1, 2 or 3, and press the §
key:
4 Press
ENTER. The word Complete
appears on the screen for about 2 seconds. The
contents of the currently-selected setup are
loaded into memory and the unit resets itself.
NOTE
Since the unit resets when a user memory is loaded, you
should make sure that the levels of all monitoring equip-
ment, etc. are turned down, to avoid thumps and possible
damage to ears and equipment.
12.4.3 Resetting the memory to factory
defaults
You may sometimes want to reset all of the memory
to factory settings. The values of all the factory set-
tings are listed in 11, Menu and parameter refer-
ence.
1 Follow the instructions regarding loading user
setups, but choose
F as the memory to load.
2 Press
ENTER. The word Complete
appears on the screen for about 2 seconds. The
factory settings are loaded into memory and
the unit resets itself.
Setup
Load 123F
Setup
Save 1 2 3
Setup
Are you sure?
3
Save 1 2
Setup
Load 123F
Setup
Load 1 2
3
F
Setup
Are you sure?
1
Load 2 3 F