Filter
Top Products
11 – Menu and parameter reference–Menu groups
78 TASCAM DA-98HR
11.1.9 Menu group 8
11.1.10 Menu group 9
Menu item Parameter(s) Values Reference
Generate Start
Time
Time value
Defaults to
00:00:00:00
9.3.2, “Recording time-
code using the genera-
tor”
Generate Mode
Run/Stop
Mode
Stop
,
Run
Reset
,
Continue
TC Frame Mode
System frame
rate, TC track
rate (view-only)
30 DF,30 NDF,
29.97
DF
,
29.97NDF
,
25 F
,
24 F
9.4, “Selecting the frame
rate”
Fs Shift Mode
Pull up/down
parameters
off
,
Pull Down 30NDF
,
Pull Up 29.97NDF
,
Pull Up 29.97 DF
,
Pull Down 30DF
9.4.1, “Pull up and pull
down (Fs shift)”
TC Record Source
Timecode
source
External TC
,
Generator
TC
,
Tape
a
a.If Tape is selected, there will be another parameter automatically appended. This parameter will be Assemble,
ABS, ABS/Offset, ABS/Auto13 or ABS/Auto23 depending on the setting made in the
Tape TC Mode menu 9.2, “Tape timecode mode”.
9.3, “Recording time-
code”
Tape TC Mode
Tape timecode
source
TcTrack
,
ABS
,
ABS-Ofs
b
,
ABS-13
,
ABS-23
b.If the ABS-Ofs (Absolute timing with offset) option is selected, the bottom line of the display changes to allow direct
entry of the desired offset value.
9.2, “Tape timecode
mode”
Menu item Parameter(s) Values Reference
Cleaning Mode
on/off
Counter
off
,
on
Automatically incremented
12.1, “Head and trans-
port cleaning”
Block Error Rate
Tape area No parameters — shows error rate at different
positions
12.2, “Checking error
rates”
Power-on Message
Startup mes-
sage
Defaults to
TASCAM HR
7.15, “Setting the power-
on message”
Setup
Setup
memories
Load/Save
1
,
2
,
3
and
F
(factory)
Load
,
Save
12.4, “User setups in
RAM”
Error Mute
enable
mute
,
no mute
7.14, “Disabling auto-
matic muting”
G e n S t a r t F s S h i f t
G e n M o d e T c R e c S r c
T C F r a m e T a p e TC
C l e a n i n g S e t u p
B E R D i s p E r r o r M u t e
P w r O n M s g