Filter
Top Products
6.1 Switching on and off
> Switch the receiver on by pressing the On/Standby
key, either on the receiver itself or on the remote
control unit.
> Pressing this key again on the receiver or on the
remote control will switch the receiver off again.
> The receiver is now in standby mode, and the display
on the receiver box front panel will show the time. If
the time is not displayed, this must still be entered into
the unit. To do this, switch the receiver on, and switch
to reception of any major channel, such as ZDF, to
enter the time automatically.
6.2 Programme Selection
6.2.1 Using the Programme up/down keys
> You can use the Programme up/down keys on the
receiver or on the remote control to move up or down
the programme list one slot at a time.
6.2.2 Using the numeric keypad
> Simply enter the desired programme number via the
numeric keypad.
For example:
1 for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numbers with more than one digit,
you have approx. 3 seconds after entering a number to
continue to the next digit. If you wish to enter a programme
number with only one or two digits, you can speed up the
switching process by holding down the last number a little
longer.
6.2.3 Using the programme list
> Press the OK key.
The programme list will now be displayed.
(Fig. 6-1)
While in TV mode, only TV programmes will be displayed,
and only radio programmes will be displayed while the
receiver is in radio mode. The programme currently selected
will be highlighted.
> You can now use the arrow keys up/down to
highlight the desired programme.
> Press the OK key to select the highlighted
programme.
> Use the arrow keys up/down to scroll through the
list one line at a time.
> Use the arrow keys left/right to scroll quickly
through the list one page at a time.
17
(Fig. 6-1)
bed_anl_DigiPal 1.qxd 23.01.03 14:42 Seite 17