Filter
Top Products
6.12.2 Manual Programming / changing timer
settings
In addition to EPG timer programming, you can also use
manual programming. To use manual programming, proceed
as follows:
> Use the Menu key to call up the Main Menu.
> Select the line Timer and confirm by pressing OK.
The menu Timer will be displayed
(Fig. 6-15).
> Press the yellow function key (New) to go to timer
programming, in order to programme a new event.
(Fig. 6-16)
> In order to change an existing timer setting, use the
arrow keys up/down to highlight this. Press the
yellow function key (Change) to go to the settings of
the highlighted timer.
In order to programme a setting, proceed as follows:
Source
> Use the arrow keys to select the category Source
and use the OK key to select the desired source (TV
or Radio).
Station/Channel
In this line you should select the TV station providing the
programme which you would like to record:
> Use the arrow keys to select the line Station.
> Confirm by pressing OK. A programme list will be
displayed.
Use the arrow keys to highlight the desired
programme.
> Confirm by pressing OK.
The highlighted programme will now be added to the
timer menu.
Date
> Use the arrow keys to highlight the category
Date.
> Use the numeric keypad to enter the recording
date.
Start
> Use the arrow key right to highlight the category
Start.
> Use the numeric keypad to enter the starting time.
Stop
> Repeat the steps as described under “Start” to enter
the time when the programme stops, or ends.
In order for the unit to cope with all these events, you should
allow a break of at least one minute between the Stop time of
a timer and the Start time of the following timer!
23
(Fig. 6-15)
(Fig. 6-16)
bed_anl_DigiPal 1.qxd 23.01.03 14:42 Seite 23