TechniSat DigiPal1 Car Video System User Manual


 
> Press the green function key (Select) to display a
selection window.
(Fig. 7-3)
> Now use the arrow keys up/down to mark the
category All in order to display all available
programmes in the Total list, or select All new to
display only new programmes found during the last
scan, or select All found to display all programmes
found during the last scan.
> Confirm by pressing OK.
Depending on your selection, a list will be displayed
showing either all programmes or all new program-
mes. Programmes that have already been entered in
the Favourites list are indicated by a check-mark.
In order to add programmes to the Favourites list, or to delete
them from this list, proceed as follows:
> Press the blue function key (Change).
> Use the arrow keys up/down to highlight a
programme you wish to add to the list.
> Simply press the green function key (Add) to add the
selected programme to the Favourites list.
In order to select several programmes at the same
time proceed as follows:
> Press the OK key to go to Selection mode.
The highlighted programme will now ne indicated by a
cross in the left margin, and the menu display will be
shown in transparent form, with the picture in the
background.
> You can now use the arrow keys up/down to
select additional programmes, and mark them.
> Once you have selected and marked all the
programmes you wish to add, press the green
function key (Add) in order to add the marked
programmes to the Favourites list.
7.1.3 Deleting programmes
7.1.3.1 Deleting from the Favourites list
If you use the above method to mark programmes with a
cross that are already in the Favourites list (marked by a
check-mark in the right margin), then pressing the green
function key (Delete) will remove these programmes from the
user table. However, they remain stored in the Total list, and
can be added to the Favourites list again at any time.
7.1.3.2 Deleting from the Total list
Pressing the red key (Delete) followed by an affirmative
response to a confirming question will cause highlighted
programmes to be deleted from the Total list.
> Highlight the programmes you wish to delete as
described above.
26
(Fig. 7-3)
bed_anl_DigiPal 1.qxd 23.01.03 14:42 Seite 26