Filter
Top Products
27-EN
01GB05IVA310.fm
ALPINE IVA-D310 68-02278Z28-A (EN)
Monitor Setting Operation
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [MONITOR].
The MONITOR screen appears.
3
Touch [] or [] of the desired item to change its
setting.
Setting items:
SLIDE / MONITOR O/C (OPEN/CLOSE)
4
Touch [RETURN] to return to the previous screen.
Touch [CONTROL] to return to the main source screen that
was displayed before the setup operation was started.
The monitor can be set in 2 positions.
Setting item: SLIDE
Setting content: BACK / FRONT
• If the monitor is forcibly pushed or pulled, you may not be able to set
the monitor angle or position. In this case, press OPEN/CLOSE to
close the monitor once, and then open the monitor again.
Setting item: MONITOR O/C (OPEN / CLOSE)
Setting content: MANUAL / FULL / CLOSE
DVD Setup Operation
The DVD Setup operation can be carried out after removing the
disc from the unit or when playback of the disc has stopped.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [OTHER SETUP].
The OTHER SETUP screen appears.
3
Touch [] of DVD SETUP.
The DVD setup screen appears.
4
Touch [] or [], etc., of the desired item to change
its setting.
Setting items:
MENU LANGUAGE / AUDIO LANGUAGE / SUBT. LANGUAGE /
COUNTRY CODE / PARENTAL / DIGITAL OUT MODE /
DOWNMIX MODE / TV SCREEN
Monitor Setting
Following Steps 1 to 4 describe the common procedures for
operating the MONITOR setting function. For details of the
setting function items, refer to descriptions of respective items.
Selecting the Monitor Position
BACK: Slides the display backwards.
FRONT: Slides the display forwards.
Setting Automatic Opening/Closing of the
Monitor
MANUAL: The monitor is manually opened or closed by
pressing OPEN/CLOSE.
FULL: The monitor automatically opens and closes when
the ignition key is turned to the “ACC” or “ON/OFF”
position.
CLOSE: The monitor automatically closes when the ignition
key is turned OFF.
Setup
DVD Setup
To display the DVD mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the DVD mode operation has been
released. Engaging the parking brake can reactivate the DVD
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of “To
display the DVD mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the DVD mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of DVD Setup. Refer to each section for details.
01GB00IVAD310.book Page 27 Wednesday, December 1, 2004 4:20 AM