75-EN
01GB07IVA310.fm
ALPINE IVA-D310 68-02278Z28-A (EN)
Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
Foot Brake Lead / Parking Brake Lead Connection
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when IVA-D310 is used individually.
• If the switched power (ignition) lead of the IVA-D310 is connected directly to the positive (+) post of the vehicle’s battery, the IVA-D310 draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
12
Vehicle Cable
Pinch Connector
Monitor Cable
Stopper
Pliers
IVA-D310
Tuner Box
Parking brake switch
(Yellow/Black)
Foot brake lamp
Foot brake switch
Battery
Chassis
Foot brake lead
Parking brake lamp
Parking brake lead
Pinch
Connector
Pinch
Connector
(Yellow/Blue)
PARKING BRAKE
FOOT BRAKE
IVA-D310
(Monitor and
Tuner Box)
(Red)
(Yellow)
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
IGNITION
BATTERY
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
01GB00IVAD310.book Page 75 Wednesday, December 1, 2004 4:20 AM