Filter
Top Products
107
Using the System
R
Using the System
Initialisation
JaguarVoice is ready to operate 10
seconds after the ignition switch is turned
to position ‘II’ (ignition on).
Driver Voice Controls
The voice button is on the left-hand side
of the steering wheel, see ‘Steering wheel
voice switches’, page 106.
Some examples of using the system are
provided on the following pages for you to
try.
Note: The system will not operate until the
radio security code has been entered.
Voice commands to the navigation system
will only operate after the navigation
caution screen has been cleared. This
must be done after every ignition cycle.
Rear Occupant Voice Controls
There are two voice buttons on the XJ rear
multimedia switchpack, see items 7 and 8
Voice button – right and Voice button -
left respectively, on the previous
illustration.
These can be operated in two different
modes:
Cabin mode – When the cabin mode
button is pressed, or when the light on the
button is illuminated, then the rear
occupants can control the audio playing
through the cabin speakers. Simply press
the voice button and give a command.
Headphone mode – When the LEFT
button is pressed, or when the light on the
button is illuminated, then the left
occupant is in headphone mode (the right
headphones control is equivalent to the
left).
In headphone mode, each occupant can
control the audio in their own headphones
by using their respective voice button,
and issuing a voice command.