Filter
Top Products
Using the System
112
L
Some Useful Notes
• Only one person at a time can use the
voice system.
• Excessive noise, for example while
driving with windows open or in
demist mode, may cause voice
command misrecognition. If it is too
noisy to use the phone, it is likely that
voice commands will not be
recognised.
• Voice commands cannot be given
while hands free phone call or radio
traffic announcement is in progress.
• If the voice button is pressed whilst a
radio traffic announcement is in
progress the announcement will be
cancelled. Press the voice button
again to start a voice session.
• While ‘LISTENING’ is displayed on the
message centre, the command can
be cancelled by pressing the same
voice button (could be a rear voice
button in the XJ) that was used to start
the voice session, except when using
the ‘PHONE ENTER’ command. To
cancel a ‘PHONE ENTER’ voice
session either say ‘CANCEL’ when
‘LISTENING’ is displayed or press the
voice button and after the end of the
beep say ‘CANCEL’. During a store
nametag session, if the voice button is
pressed and released during
‘LISTENING’, the system will cancel
after up to 2 seconds.
• Voice feedback can be interrupted by
pressing the voice button that was
used to start the voice session, whilst
the feedback is playing.
• After starting to speak, the command
must be completed within 10
seconds.
• During a voice command the audio
system and direction indicator ticking
will be muted.
• The voice session will be cancelled if
an alternative message requires the
display/speaker (e.g. incoming phone
call or radio traffic announcement).