Filter
Top Products
45
Radio
R
RDS Trouble-shooting Guide
Incorrect response from RDS Reason and reaction
Radio does not display programme
name.
Check that RDS is turned on by pressing and
holding the TA button until the display confirms
RDS ON. If the radio does not display a
programme service name, it is not broadcasting
RDS data, or you are in a poor reception area.
Try re-tuning to another station with RDS.
Station name is lost and displays
frequency only.
Radio has lost reception of the RDS data due to
vehicle moving out of transmitter range, loss of
signal in a tunnel, under a garage forecourt
canopy, or similar screening. If the latter is the
case, when the vehicle is clear of the screening,
the station name will return after a short delay.
Upon operating A MEM NO FM is
displayed when most or all of the
preset positions are selected.
The radio cannot locate nine FM, RDS FM or TP
stations dependent upon the mode selected. If
this occurs, switch off RDS or TA and reselect A
MEM.
Upon pressing the TA button the
radio re-tunes to another station
and displays TP SEEK.
The station selected does not have TP/TA
facility, the radio will re-tune to one that does.
Radio sound goes off and the
display shows PI SEEK.
The RDS radio station selected is unable to
confirm that the frequency tuned to has the
correct RDS data – programme identification
(PI). It will then seek for a frequency that has the
correct data.
Radio ‘beeps’ and the display
shows NO TA/TP and turns off TA.
The vehicle is in an area where TA broadcasts
cannot be received from any FM stations. The
radio will automatically deselect the TA feature.