Filter
Top Products
94
IntelliTouch ScreenLogic User’s Guide
IntelliFlo 4x160 Alarm and Warnings
The IntelliFlo 4 alarm and warnings are indicated by flashing LEDs on the control panel. For example, if
a “Drive Temperature” warning occurs, the LED will blink two times, then Off, then blink two times. This
sequence is repeated until the condition is cleared.
• Warning condition: If a warning condition occurs the pump will be continue to run but at a
reduced speed. The Green LED executes a sequence of blinks to indicate which alarm or
warning has occurred.
• Alarm condition: If an alarm condition occurs the pump will drive stop running. The red LED
flashes continuously to indicate the presence of an alarm. The alarm LEDs will reset when the
condition clears.
For IntelliFlo troubleshooting information, see the IntelliFlo 4x160 Installation and User’s Guide
(P/N 357269).
Alarm and warnings LED sequence
ehtemitforebmuN
knilblliwDEL
mralAnoitpircseDnoitcA
2gninraWerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.noitalitnevrofaeraetauqeda
.looco
twolladnarotompotS.2
otdeepsrehgihatarotomnuR.3
.wolfriagniloocevorpmi
5mralanwonknUeruliafnortcelE.pmupteserotrewopelcyC.1
.evirdecalpeR.2
6mralAerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.noi
talitnevrofaeraetauqeda
otdeepsrehgihatarotomnuR.2
.wolfriagniloocevorpmi
7mralAtuOrewoPwolegatlovylppuS.eg
atlovylppusreporperusnE
8mralAtnerrucrevOtnerrucevirdevissecxElacinahcem/diulfenimaxE.1
.daolrevofoecruosr
ofmetsys
dnarotomezigrene-eD.2
.yleerfsnipsrotomfienimreted
.evirdecalpeR.3
9mralAegatlovrevO ssubevirdnoegatlovevissecxEsdeepsneewtebgnihctiwsdipaR.1
segatlovevissecxeesuacnac
.ssubCDs'evirdehtno
.egatlovylppusr
eporperusnE.2