Filter
Top Products
66
IntelliTouch ScreenLogic User’s Guide
Color Set Lighting Feature
The Color Set feature allows any combination of up to 12 SAm, SAL, IntelliBrite, or FIBERworks lighting circuits
to be preset to specific colors. This feature requires at least one SAm, SAL, IntelliBrite, or FIBERworks lighting
product controlled by separate AUX circuits.
To set up Color Set lights:
1. From the Main screen, tap the Lights tab.
2. Tap the Configure Colors tab.
3. Tap the color for SAm, SAL, IntelliBrite, or FIBERworks lights. Each, then tap the Color Set button to
preset the lights to the selected color. The Special Lights bar indicates the progress.
4. Tap the Main tab when finished to return to the main screen.
Set up Swimming Colors (Color Swim)
This feature requires at least one SAm, SAL, IntelliBrite, or FIBERworks lighting product be controlled by separate
AUX circuits.
To set up Swimming Colors lights:
1. From the main screen, tap the Lights tab.
2. Tap the Configure Colors tab.
3. Tap the Configure Color Swim tab.
4. Select a displayed pool or spa light. Tap either of the side arrows to set delay time between the lights. To
achieve different swimming color effects, try setting SAM 1 light to 0 seconds, then set SAM 2 to 16
seconds. Set a higher delay time for lights that are spread further apart. Use the Load Defaults button to
reset the delay time to 5 seconds between all lights.
5. Tap Color Swim to activate the swimming color feature. The Special Lights bar indicates the progress.
Note: It may take up to a minute or more for Color Swim, or Color Sync to function as programmed
depending on what kind of light you are activating and what state it was in when the effect was
activated. The displayed red bar under the Special Lights buttons, indicates the progress.