Filter
Top Products
97
IntelliTouch ScreenLogic User’s Guide
ScreenLogic Wireless Connection Kit
The ScreenLogic Wireless Connection kit (P/N 520639) consists of two wireless 900 Mhz transceivers which
provides a wireless connection between the ScreenLogic Protocol adapter and the IntelliTouch Load Center
located at the equipment pad. This wireless connection eliminates the existing hard wire connection from inside
your home to the equipment pad.
The diagram below shows the wireless transceiver locations. The transceiver connected to the IntelliTouch Load
Center is connected to the Personality board COM port. The other transceiver is connected to the Protocol
Adapter located inside the home.
Load Center to Protocol Adapter wireless connection diagram
Cable distance limits:
- Ethernet cable distance limit = 300 feet
- Four-wire cable distance limit = 1500 feet
Note: (*) Optional wiring for existing Indoor
Control Panel. Tap into the Indoor Control Panel
connector or pig tail off the four-wire cable
connected to the Personality board.
1
234
WAN
RJ11
RJ45
INTERNET
1
234
WAN
- LAN -
Existing wired or wireless
router (mandatory)
RJ11 for DSL
Coax for Cable
In-wall touch
screen
Wireless transceiver
connected to Personality
board (COM port)
via 10’ cable
Protocol
Adapter
ScreenLogic
Wireless router
Wireless Digital Tablet
Wireless PDA
Indoor Control
Panel (*)
Existing PC
Ethernet cable (RJ45 - CAT 5)
Ethernet cable
(RJ45 - CAT 5)
DSL or
Cable Modem
(RJ45)
Transceiver
connected to
ScreenLogic
Protocol adapter
Load Center
(Located outside at
equipment pad)
4-wire 1 foot cable
AC power
adapter