Filter
Top Products
16
IntelliTouch ScreenLogic User’s Guide
Before You Begin
Your IntelliTouch ScreenLogic PDA, wireless Tablet, and in-wall touch screen are pre-configured and ready for
operation. The system hardware includes a Protocol adapter, a wireless router, and your choice of wired or wireless
interface. The following describes the different set up options which depend on the type of Personality Kit being
used:
• iTC15 Kit (P/N 520500) – Includes Protocol Interface Adapter and wireless router that connects to existing
Desktop or Laptop PC. This allows control of IntelliTouch pool and spa systems via PC (requires PC with
an Ethernet connection, and Windows XP operating system).
• iTC25 Kit (P/N 520501) – Includes Wireless Personal Digital Assistant (PDA) with 3.5" color touch screen
custom configured for IntelliTouch systems, wireless router, and a Protocol Interface Adapter.
• iTC35 Kit (P/N 520502) – Includes in-wall color touch screen with Ethernet (RJ45) connection and
Protocol Interface Adapter and wireless router. The Touch screen device is custom configured for
IntelliTouch systems.
• iTC45 Kit (P/N 520503) – Includes wireless digital Tablet with color touch screen, Protocol Interface
Adapter, and wireless router. The Tablet device is custom configured for IntelliTouch systems.
Tools Required
• Wire stripping tool (for stripping cable wires)
• Ethernet connector tool (for custom Ethernet cabling)
Connection Steps Summary
Before connecting the ScreenLogic interface, the IntelliTouch Load Center and Personality Kit should already be
installed. The recommended ScreenLogic installation steps are:
Switch power off to the IntelliTouch Load Center: Before connecting cables to the IntelliTouch
Protocol adapter, switch off the power source to the Load Center.
Review the location requirements before installing the wireless router and Protocol adapter
(pages 17 - 23).
Connect the IntelliTouch Protocol Adapter (pages 24 - 25): Connect a 22-gauge four-wire cable to
the IntelliTouch Protocol adapter and to one of the available COM ports on the Personality board located in
the Load Center. If both ports are in use, you can wire into the COM port connection block.
Connect to the Wireless Router (page 21 - 23): Connect an Ethernet cable from the IntelliTouch
Protocol adapter to the IntelliTouch wireless router ports 1-4.
Start up the IntelliTouch ScreenLogic System (page 27): Verify cable connections. Power-up the Load
Center and wireless router.
1
2
3
4
5