Filter
Top Products
13
IntelliTouch ScreenLogic User’s Guide
Using your ScreenLogic Interface
Please read the following important information before operating your ScreenLogic interface.
Important Precautions (Tablet, PDA, and In-wall Touch Screen)
Before you use this device, please read this manual for setup procedures, safety precautions, and other important
information. Please review the contents even if you are an experienced user. If you have any problems, contact
Technical Support. For Technical Support contact information refer to page viii.
• The Digital Tablet and PDA must be used and stored inside.
• Keep the Digital Tablet, PDA, and in-Wall touch screen dry. Do not expose the device to moisture.
• Always exercise care when operating and handling the Digital Tablet, PDA, and in-wall touch screen.
• Do not apply excessive pressure to the display screen.
• Avoid exposing the panel screen to direct sunlight or other heat source for an extended period of time.
Where possible, the Tablet and PDA should be facing away from direct lighting to reduce glare.
• If the AC adapter is used to recharge or power the device, DO NOT use any AC adapter other than the one
provided with the device or acquired from the manufacturer or its distributors.
• Never attempt to disassemble the Digital Tablet, PDA, or in-wall touch screen. You will lose any product
warranty on the product.
Cold Boot/Power On-Off/Reset (Tablet and In-Wall Touch Screen)
You may use the Suspend Button to cold-boot or Restart the Digital Tablet in the unlikely event of device lockup.
To execute, hold the button for over four seconds to “Power Off” the device. The device will be turned off. This
Reset/Power Off will clear your software settings and data if they are not properly saved to flash memory (see
“Save Tablet System Settings” below). Push again on Suspend Button for a brief moment to restart/reboot the
device. To cold-boot or restart the in-wall touch screen, press and hold for four-seconds the round four-way
directional button on the front of the in-wall touch screen.
Cold Boot/Power On-Off/Reset (PDA)
Insert the stylus into the reset hole on the back of the PDA to cold-boot or reset. (Only required if the PDA stops
responding or has wireless connection problems.)
Save System Settings (Tablet and In-Wall Touch Screen)
Make sure to save your system registries settings in flash memory in the event of a Reset/Power Off. Your system
settings such as date, time, screen brightness can be saved in flash memory.
To save your settings do the following:
1. Tap Start > Settings > Control Panel > Registries Save/Restore.
2. Tap the Save Current Settings check box.
3. Tap OK in Message dialog, to save your settings into persistent storage.
4. Tap OK again to confirm.
5. Tap OK to exit.