Filter
Top Products
120
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
Adding and Moving Markers
A Marker is a position in the conference
that is linked to an Index point, an
Image or both. When playing the
conference, clicking on an Index point
will forward the movie to that Marker
location. When the movie reaches a
Marker that has an image attached,
the image will be displayed in the
Presentation tab of the viewer.
Conference markers are displayed when
the Markers tab is clicked. Markers can
be selected from the markers tab list
one at a time.
To select a marker in the Content
Editor, click on:
the marker’s select box or
the marker number or
the marker time
When a marker is selected from the list,
an orange rectangle will display around
the marker’s number, timecode, image
and index. A small inverted triangle
will be shown in the timeline of the
controller to mark the position of the
marker in the conference.
•
•
•
About Markers
Adding Markers
Moving Existing Markers
Adding markers into the timeline is done by clicking the Add Marker
button while the clip is playing. A small inverted triangle at the
centre point of the scrub-bar in the timeline will be added to indicate
the position of the added marker.
This will also add a marker within the Markers tab positioned in time
order, with Add Image and Add Index buttons available.
At this stage, the markers make no difference to the users watching
the conference as there is nothing attached to them.
There are two ways of doing this; by editing the timecode or by
dragging the marker.
Editing the TIMECODE of the marker:
Change the time (format is hh:mm:ss.000) in the time field and
press enter. The marker in the timeline will move to the new
location.
By dragging the marker:
The marker in the timeline can also be dragged to its new position
and the timecode will also change. The marker will be displayed in
the timeline when the corresponding timecode is selected as in the
screen shot below.
Times entered as seconds will be converted.
Example: 65 will be converted to 00:01:05.000.
Viewing Conferences > Editing Contents