Filter
Top Products
27
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006
About Restoring to Factory Settings
Restoring to Factory Settings
The administrator can restore the Content
Server to factory settings partially or fully via
the LCD panel.
A partial restore to factory settings – Config
Restore - restores the factory configuration
files and templates, but does NOT affect the
content stored on the server.
A full restore to factory settings – Full Restore
– removes content and deletes all media files
in addition to restoring the factory configura-
tion files and templates.
Restoring to factory command in v.2.0
will restore the Content Server to v.2.0
defaults, but it will also remove any
configurations specific to v.1.x, if the Content
Server has been upgraded to v2.0 from v1.x!
Config Restore
Deletes all user-created Recording Aliases, Call
Configuration files and Recording Templates
and restores them to v.2.0 defaults.
Full Restore
Deletes all user-created Recording Aliases, Call
Configuration files, Categories and Recording
Templates and restores them to v.2.0 defaults.
Deletes all conferences and media files
Deletes all server logs
If data location has been changed to an ex-
ternal storage location (NAS), a full restore
will change the default storage location
back to the Content Server.
•
•
•
Restoring to Factory Settings
Command Menu Structure
IP Settings
Commands
Restart?
No
Yes
Shutdown?
No
Yes
- Restore Factory -
Full Restore
Config Restore
Full Restore?
No
Yes
Config Restore?
No
Yes
Restart and Shutdown
are described on the
previous page.
IP Settings are
described in
Installation.
Press Enter to display the Main Menu
screen.
From the Main Menu screen, use
the Up or Down arrow to select
Commands.
Press Enter to confirm your selection.
From the Commands menu, use the
Up or Down arrow to select Restore
Factory and press Enter.
From the Restore Factory menu, use the Up or Down arrow to select Full Restore
or Config Restore and press Enter.
Used to enter the edit
mode and confirm
selection or entry.
Used to return to the
previous menu screen
or exit the edit mode
without saving the lat-
est entry.
Used to select items
in the menu, move
between values in a
numerical address
and modify numerical
values.
For an example of this, turn to
IP Address Setting Configuration
in the Installation section.
Basic Operating Principles
!
Front Panel Keys